Share via


System Settings

You can change the default system settings for your run-time image. These settings include computer name, workgroup membership, pagefile support, and power management.

If these values are left blank, during the FBA process a unique computer name will be assigned to the device, and additional default values will be used for your system settings.

The following list shows the System Identification values that are configured in one of the following Hardware Abstraction Layer (HAL) components. These values depend on the base hardware of your device:

  • ACPCI Multiprocessor PC
  • ACPCI Uniprocessor PC
  • Advanced Configuration and Power Interface (ACPI) PC
  • Compaq SystemPro Multiprocessor or 100% Compatible
  • MPS Multiprocessor PC
  • MPS Uniprocessor PC
  • Standard PC

Within each of these components you can change the system identification, pagefile settings, or power management settings.

In This Section

  • Design a Run-Time Image
    Describes the design phase of the development process. During this phase you can choose the components and resources that are required for your run-time image.
  • Network Configuration
    Describes how to configure networking on your run-time image.
  • Power Management
    Describes the different power management schemes you can use with your run-time image.

Last updated on Wednesday, October 18, 2006

© 2006 Microsoft Corporation. All rights reserved.