ShellProc Messages (Windows CE 5.0)
The following table shows the ShellProc messages for Tux.
| Programming element | Description |
|---|---|
| SPM_LOAD_DLL | This message is sent once to the DLL immediately after the DLL loads. |
| SPM_UNLOAD_DLL | This message is sent once to the DLL immediately before the DLL unloads. |
| SPM_SHELL_INFO | This message is sent once to the DLL immediately following the SPM_LOAD_DLL message to give the DLL information about Tux. |
| SPM_REGISTER | This message is sent once to the DLL immediately following the SPM_SHELL_INFO message to query the DLL for its function table. |
| SPM_START_SCRIPT | This message is sent to the DLL immediately before a script starts. This message is sent to all loaded DLLs, including loaded DLLs that are not in the script. |
| SPM_STOP_SCRIPT | This message is sent to the DLL after the script stops. This message is sent when the script reaches its end or when you stop the script. |
| SPM_BEGIN_GROUP | This message is sent to the DLL before a single test or group of tests from that DLL executes. |
| SPM_END_GROUP | This message is sent to the DLL after a group of tests from that DLL finishes running. This message gives the DLL time to clean up after it runs. |
| SPM_BEGIN_TEST | This message is sent to the DLL immediately before a single test executes. |
| SPM_END_TEST | This message is sent to the DLL after a single test case from the DLL executes. |
| SPM_EXCEPTION | This message is sent to the DLL whenever code execution in the DLL causes an exception fault. |
See Also
Send Feedback on this topic to the authors