Manual Connection of the CETK to a Target Device
Other versions of this page are also available for the following:
.gif "A hyphen indicates that the information in this topic is not relevant for this platform, or that the platform does not support the API that is listed.")
.gif "A checkmark indicates that the information in this topic is relevant for this platform, and that any API listed is also supported on this platform.")
8/27/2008
You can manually establish a connection between the CETK and a target device.
For information about using Platform Manager to establish a connection instead of manually establishing a connection, see Connecting the CETK to a Target Device by Using Platform Manager.
In This Section
- Configuring the CETK to Communicate with a Target Device
Tells how to configure the CETK port number settings and starting the Clientside.exe application to communicate with the device under test.
- Running the CETK Tool without the CETK Client in the Run-Time Image
Discusses how to add support for the CETK to a target device that has a run-time image without support for the CETK.
- Wcetk.txt and Clientside.exe Settings for the CETK
Describes the settings for these files.
- ** Adding Support for the CETK to an OS Design in Platform Builder **
Discusses adding CETK support to your OS in PB before building the run-time image.
- ** Running the CETK Client on a Target Device Connected to Platform Builder **
Discusses running the CETK using PB.